Make a No-Slip Woven Workout Headband with Goldfish Kiss

The secret to a stay-put band? Shelf liner!

DIY // Goldfish Kiss // 01/25/12
/ / RSS




Stay-put-1_span7
By Goldfish Kiss

Materials for the DIY headband

Stay-put-2_span7
By Goldfish Kiss

Step 1: Cut five 2" strips off the bottom of an old t-shirt. (These will be in a circle after you cut them off, cut each along one side seam to make a long strip)

Stay-put-3_span7

Step 2: Sew ends of the strips together on one side

Stay-put-4_span7
By Goldfish Kiss

Step 3: Safety pin sewn end to a blanket, couch or pillow

Stay-put-5_span7
By Goldfish Kiss

Step 4: Make a 5 strand weave by following the steps below

Stay-put-7_span7
By Goldfish Kiss

Step 5: Roll out the shelf liner and cut a strip that just about as wide as the headband (about an inch)

Stay-put-8_span7

Step 6: Sew liner in place on the underneath side (so it doesn't show through on the front) every 3 inches or so. *If you own a glue gun, you could use that now instead.

Stay-put-9_span7
By Goldfish Kiss

Step 7: Sew the headband strip ends together to make it a loop. With another strip from the shirt or any excess scraps. Sew one end on the inside of the headband where the ends are all sewn together. Wrap the strip around securely, then sew a knot to secu

Stay-put-11_span7
By Goldfish Kiss

I have one dilemma when working out: no headbands stay put on my head...ever. Blame it on fine hair and an oddly shaped head, then add bangs at an awkward length and I have quite the dilemma and tying a bandana around my head like Rambo just won't cut it.

There's a little trick to make one stick: shelf liners. Yup, those $2 rolls of woven grip liners that keep kitchen goods in place is also the secret ingredient for a fidget-free yoga class, the cutest messy top knot ever, or a run on the beach minus sweaty strands.

What You'll Need:
-Old shirt you can cut
-Grip shelf liner
-Scissors
-Needle
-Sturdy thread (I use dental floss–it's super strong and I have it around the house)
-Safety pin.

The Five Strand Weave
• Divide the 5 strands into 2 sections, 3 strands to the one side, 2 to the other.
• On the 3 strand side, working from the outside in, place the furthest strip over the second strip, then under the third.
•Bring it to the other side (the side with 2 strands) so that side now has 3 strands.
• Repeat again, take the furthest strand outside on the side with 3, over the next, under the next, over to other side that had 2 strands.
• Keep on repeating and pulling the strands tight as you go.

See more recipes, workouts and tips from our Health & Guest blogger Goldfish Kiss!
Read the Goldfish Kiss blog!



Next Article

In the Curl

How to Wear Head to Toe Lace


Add a Comment

You need to log in to comment on this article. No account? No problem!